Boatbuilding Blog

January 25, 2010

110-Volt Wiring and Sliding Doors

Filed under: Building - Cabin, Building - Electric & Plumbing — tomlarkin @ 12:29 pm

After a few weeks off I’m now working on the sliding doors and the 110 volt wiring. This wiring is pretty basic – three GFI’d duplex outlets and the battery charger. I’m running all the high voltage wiring in plastic conduit, most of which is installed now.

The sliding doors are coming along, but slowly. There’s a lot of work to make them. They’re 3/4 ply with 1/4-inch ply laminated on either side.  Here’s a mockup of a door, complete with window and handrail. It’s hanging from a plastic slug in a stainless sail track. There is too much resistance with this system, so I’m going to try a ball-bearing slider instead.
Sliding door mockup installed

I installed the bronze bow cleat today. I decided not to use the stainless bit I bought. It just seemed like overkill. The cleat uses 2 1/2 inch bronze bolts, through 1 1/2 inches of marine plywood, and a doubled 1/8 inch bronze backing plate. It should be strong enough 😉
IMG_0303  IMG_0304
Cleat backing plates

Conduit for 110 volt wiring is mostly installed.
Conduit and junction box below 110 volt panel
Conduit to battery charger and outlets

Advertisements

1 Comment »

  1. Looking good!

    I’m interested in how you hang your sliding door. I have a similer application and I’m not sure how to do it.

    Comment by Bill — January 26, 2010 @ 12:53 am


RSS feed for comments on this post. TrackBack URI

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: